SuperX AIO V2
Check Out Our Other Happymodel Products!
Upgrade your 1S micro fleet with the Happymodel SuperX AIO V2. This 5-in-1 flight controller is the ultimate “brain” for ultralight 65mm and 75mm whoops. Packing an F4 processor, 5A ESCs, and a high-power video transmitter into a standard 25.5mm footprint, it delivers pro-level performance without the weight penalty.
True Serial ExpressLRS (UART)
Say goodbye to the limitations of SPI receivers. The SuperX V2 features a built-in Serial ExpressLRS 2.4G Receiver connected via UART. This allows for independent firmware updates via Wi-Fi or Betaflight passthrough, ensuring you can always run the latest ELRS version (3.x.x compatible) without needing to flash the entire flight controller.
High-Power OpenVTX (Up to 400mW)
Fly further and clearer. Unlike standard whoop boards capped at 25mW, the SuperX V2 integrates an OpenVTX module capable of outputting up to 400mW. Controlled via MSP (Betaflight OSD), this VTX gives you the signal penetration needed to fly behind walls or explore outdoors with confidence.
Optimized for 1S Performance
Designed for pure 1S speed, the onboard 5A 4-in-1 ESCs come pre-flashed with Bluejay firmware, enabling bi-directional DSHOT for smoother flight and RPM filtering. The board comes with an A30 Power Connector (fully compatible with BT2.0), which significantly reduces voltage sag compared to older PH2.0 connectors, giving you more punch and longer flight times.
Key Features:
-
5-in-1 Design: FC, ESC, RX, VTX, and OSD on a single board.
-
Serial ELRS: UART-based receiver for easy Wi-Fi updates.
-
Long Range Video: OpenVTX adjustable from 0mW to 400mW.
-
Bluejay Ready: 5A ESCs support 48kHz/96kHz for efficiency.
-
High-Flow Power: Includes A30 connector (BT2.0 Compatible).
-
Modern Gyro: BMI270 sensor for locked-in PID loop performance.
Specifications:
-
Model: SuperX F4 5A AIO V2
-
MCU: STM32F411CEU6 (100MHz)
-
Gyro: BMI270 (SPI)
-
Mounting: 25.5mm x 25.5mm (Whoop Standard)
-
Input Voltage: 1S (DC 2.9V – 4.35V)
-
ESC: 5A Continuous / 6A Peak (Bluejay Firmware O-H-5)
-
Receiver: Serial ELRS 2.4G (UART / CRSF Protocol)
-
VTX: 5.8G OpenVTX (Up to 400mW)
-
Antenna Connector: U.FL (VTX) / Copper Wire (RX)
-
Connector: A30 (Compatible with BT2.0)
What’s in the Box?
-
1x Happymodel SuperX AIO V2 Flight Controller
-
1x A30 Power Pigtail
-
1x VTX Antenna (U.FL)
-
1x Hardware / Damper Set
