Walksnail Avatar Kit Power Cable
Need to replace a damaged cable or planning a new build with your Walksnail Avatar HD system? This is the official replacement 6-pin power and data cable. It’s the essential drone part needed to connect your Walksnail VTX to your flight controller, providing both power and the data link for displaying your OSD information.
The Essential Connection
This single harness simplifies your build by handling all the necessary connections to your Walksnail VTX. The 6-pin connector plugs directly into the Air Unit or VTX module, while the other end provides pre-tinned wires for soldering to your flight controller’s power output (VCC/GND) and a free UART (TX/RX). This allows your flight controller to send data to the VTX for a full Betaflight, iNav, or Ardupilot OSD experience on your HD display.
Crafted with high-quality, flexible silicone wires, this cable is heat-resistant and easy to route through even the most compact FPV drone frames.
Key Features:
- Official Replacement Part: Guarantees a perfect fit and correct pinout for all Walksnail Avatar HD VTX/Camera kits.
- Power & Data in One: A single, clean cable provides both input power and the UART data connection to your VTX.
- High-Quality Silicone Wires: Flexible and resistant to heat, making them easier to route and more durable than standard PVC wires.
- Standard 120mm Length: Provides ample length for clean routing in most 3-inch to 7-inch FPV drone frames.
- Essential Spare Part: Perfect for having on hand for quick repairs after a crash or for moving your HD system to a new frame.
Specifications
- Brand: Walksnail
- Product: 6-Pin VTX Power/Data Cable
- Compatibility: Walksnail Avatar HD VTX / Camera Kits
- Connector: 6-Pin JST-SH (on VTX side)
- Length: 120mm (approx. 4.7 inches)
- Wire: High-Quality Silicone
Includes
- 1x Walksnail Avatar 6-Pin Power & Data Cable (120mm)