Happymodel is joining the fun with something on the larger end of the toothpick spectrum. Check out the performance in the flight videos below!

Features

• New Crazybee F4 PRO V3.0 AIO Flight controller
• Powerful and smooth
• Betaflight OSD support ,easy to get RSSI, Voltage ,current from your goggles
• Camera Angle adjustable
• VTX power switchable 25mw~200mw
• Smartaudio ready , change VTX bands, powers, channels via OSD
• Receiver: Frsky D8
• Diamond VTX Ready
• HappyModel recommends both 2s-3s Lipo/LIHV batteries

Specifications

• Wheelbase: 100mm
• Size: 88mm*88mm*45mm(without propellers)
• Weight: 50g(without battery)
• Recommended Battery: 3S 300mah/350mah  2S 450mah

Spare Parts Specifications:

• Motor: EX1103
• KV options: KV7000
• Configu-ration:9N12P
• Stator Diamter:11mm
• Stator Length:3mm
• Shaft Diameter: Φ1.5mm
• Motor Dimension(Dia.*Len):Φ13.5mm*16mm
• Weight(g):3.7g

Flight controller

• (Frsky version) CRAZYBEE F4FR PRO V3.0 Firmware target: CrazybeeF4FR
• MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
• Sensor: MPU-6000(SPI connection)
• Board size: 28.5 * 28.5MM
• Power supply: 2-4S battery input (DC 7-17V)
• Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready
• Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable)
• Built-in Betaflight OSD(SPI Control)
• Built-in Current meter Max 70A
• Current meter scale set to 470
• Built-in 5V 1A BEC
• Built-in voltage detection

Onboard 4in1 ESC

• MCU upgraded to EFM8BB21
• Power supply: 2-4S LiPo/LiPo HV (7v/17v)
• Current: 10A continuous peak 12A (5 seconds)
• Support BLHeliSuite programmable
• Factory firmware: F_H_40_REV16_5.HEX
• Default protocol: DSHOT600

Internal Frsky NON-EU Receiver Version

• SPI BUS receiver
• Frsky D8/D16 switchable
• Compatible Non EU transmitter both D8 and D16 mode
• Channels: 8ch or 16ch
• Failsafe support
• No ground interference ( Transmitter and receiver 1 m from the ground): 300m

Diamond_VTX

• Output power: 25~200mw switchable
• Frequency: 40CH
• Input voltage: 3.3V 5.5V
• Current consumption: 250mA~510mA(type)
• Antenna: RG178 antenna
• U.FL interface
• Frequency: 5.8GHz 5bands 40 channels
• With Raceband
• Smartaudio ready
• Weight: 3g without antenna
• Video Output Size: VGA (640×480)
• Video Output format: NTSC
• Record video size : 1280×720 @25FPS
• TF Card support: Max.32G
• Interface: JST SH1.0 3pin for Camera
•         JST SH1.0 5pin for Connect with F3/F4 Flight controller
• Compress Format: AVI

Runcam NANO2

• Model: Nano 2
• Image Sensor: 1/3″ CMOS
• Horizontal Resolution: 700TVL
• Lens: 2.1mm(M8) FOV 155°
• Signal System: NTSC / PAL
• S/N Ratio: >50dB
• Electronic Shutter Speed: Auto
• Auto Gain Control (AGC): Auto
• Min. Illumination: 0.01Lux@1.2F
• D-WDR: Auto
• Day/Night: Color
• Power: DC 3-5.5V
• Current : 110mA@5V 120mA@3.3V
• Housing Material: ABS
• Net Weight: 3.2g
• Dimensions: L14mm*W14mm*H16mm

Includes

• 1x HappyModel Larva X 2-3S BNF 2.5″ Micro Drone