Prop Tool
Check Out Our Other Happymodel Products!
Stop hurting your fingers and bending your motor shafts! The Happymodel Propeller Disassembly Tool is the essential pit-crew accessory for every Tiny Whoop pilot. Designed specifically for the tight tolerances of micro drones, this tool allows you to safely remove press-fit propellers without damaging your delicate motors.
Save Your Motors
Pulling propellers off by hand is the #1 cause of bent motor shafts and warped bells on micro motors (0702, 0802, 1102, etc.). This tool uses a leverage-based design (or a pin-push design, depending on the specific batch style) to apply even pressure against the shaft, popping the propeller off smoothly while keeping the motor internals safe.
Universal Micro Fit
Whether you are flying a Mobula6, Mobula7, Mobeetle, or a custom 2-inch toothpick, this tool is compatible with most standard micro motors and press-fit propellers. It is compact enough to fit in your pocket or field kit, ensuring you are always ready for a prop change.
Key Features:
-
Motor Saver: Prevents bent shafts caused by hand removal.
-
Easy to Use: Removes stubborn press-fit props with minimal effort.
-
Universal: Works on 0.8mm, 1.0mm, and 1.5mm shaft micro motors.
-
Compact: Small and lightweight addition to your tool kit.
Specifications:
-
Product: Propeller Disassembly Tool
-
Application: Micro Drones / Tiny Whoops
-
Function: Press-fit Propeller Removal
What’s in the Box?
-
1x Happymodel Propeller Disassembly Tool
